/*-
 * Copyright (c) 2003-2009 RMI Corporation
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. Neither the name of RMI Corporation, nor the names of its contributors,
 *    may be used to endorse or promote products derived from this software
 *    without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
 * ARE DISCLAIMED.  IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
 * SUCH DAMAGE.
 *
 * RMI_BSD */
#ifndef _RMI_ATX_CPLD_H_
#define _RMI_ATX_CPLD_H_

/*
 * bit_0 : xgs0 phy reset, bit_1 : xgs1 phy reset, bit_2 : HT reset, bit_3 :
 * RTC reset, bit_4 : gmac phy soft reset, bit_5 : gmac phy hard reset, bit_6
 * : board reset, bit_7 : reserved
 */
#define ATX_CPLD_RESET_1   2

/*
 * bit_0_2 : reserved, bit_3 : turn off xpak_0 tx, bit_4 : turn off xpak_1
 * tx, bit_5 : HT stop (active low), bit_6 : flash program enable, bit_7 :
 * compact flash io mode
 */
#define ATX_CPLD_MISC_CTRL 8

/*
 * bit_0 : reset tcam, bit_1 : reset xpak_0 module, bit_2 : reset xpak_1
 * module, bit_3_7 : reserved
 */
#define ATX_CPLD_RESET_2   9

#endif				/* _RMI_ATX_CPLD_H_ */