1 .\" Copyright (c) 2006 Scott Long
2 .\" All rights reserved.
4 .\" Redistribution and use in source and binary forms, with or without
5 .\" modification, are permitted provided that the following conditions
7 .\" 1. Redistributions of source code must retain the above copyright
8 .\" notice, this list of conditions and the following disclaimer.
9 .\" 2. Redistributions in binary form must reproduce the above copyright
10 .\" notice, this list of conditions and the following disclaimer in the
11 .\" documentation and/or other materials provided with the distribution.
13 .\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
14 .\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
15 .\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
16 .\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
17 .\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
18 .\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
19 .\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
20 .\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
21 .\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
22 .\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
32 .Nd "LSI MegaRAID SAS driver"
34 To compile this driver into the kernel,
35 place the following lines in your
36 kernel configuration file:
37 .Bd -ragged -offset indent
42 Alternatively, to load the driver as a
43 module at boot time, place the following line in
45 .Bd -literal -offset indent
49 This driver is for LSI's next generation PCI Express SAS RAID controllers.
50 Access to RAID arrays (logical disks) from this driver is provided via
53 A simple management interface is also provided on a per-controller basis via
60 name is derived from the phrase "MegaRAID Firmware Interface", which is
61 substantially different than the old "MegaRAID" interface and thus requires
63 Older SCSI and SATA MegaRAID cards are supported by
65 and will not work with this driver.
67 Two sysctls are provided to tune the
69 driver's behavior when a request is made to remove a mounted volume.
70 By default the driver will disallow any requests to remove a mounted volume.
72 .Va dev.mfi.%d.delete_busy_volumes
74 then the driver will allow mounted volumes to be removed.
76 A tunable is provided to adjust the
78 driver's behaviour when attaching to a card. By default the driver will
79 attach to all known cards with high probe priority. If the tunable
80 .Va hw.mfi.mrsas_enable
82 then the driver will reduce its probe priority to allow
84 to attach to the card instead of
89 driver supports the following hardware:
95 LSI MegaRAID SAS 8408E
97 LSI MegaRAID SAS 8480E
101 LSI MegaRAID SAS 9260
107 IBM ServeRAID M1015 SAS/SATA
109 IBM ServeRAID M1115 SAS/SATA
111 IBM ServeRAID M5015 SAS/SATA
113 IBM ServeRAID M5110 SAS/SATA
117 Intel RAID Controller SRCSAS18E
119 Intel RAID Controller SROMBSAS18E
122 .Bl -tag -width ".Pa /dev/mfid?" -compact
124 array/logical disk interface
130 .It "mfid%d: Unable to delete busy device"
131 An attempt was made to remove a mounted volume.
140 driver first appeared in
145 driver and this manual page were written by
146 .An Scott Long Aq scottl@FreeBSD.org .
148 The driver does not support big-endian architectures at this time.