2 .\" Nick Hibma <n_hibma@FreeBSD.org>. All rights reserved.
4 .\" Redistribution and use in source and binary forms, with or without
5 .\" modification, are permitted provided that the following conditions
7 .\" 1. Redistributions of source code must retain the above copyright
8 .\" notice, this list of conditions and the following disclaimer.
9 .\" 2. Redistributions in binary form must reproduce the above copyright
10 .\" notice, this list of conditions and the following disclaimer in the
11 .\" documentation and/or other materials provided with the distribution.
13 .\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
14 .\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
15 .\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
16 .\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
17 .\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
18 .\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
19 .\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
20 .\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
21 .\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
22 .\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
32 .Nd USB Double Bulk Pipe driver
34 To compile this driver into the kernel,
35 place the following line in your
36 kernel configuration file:
37 .Bd -ragged -offset indent
41 Alternatively, to load the driver as a
42 module at boot time, place the following line in
44 .Bd -literal -offset indent
50 driver provides support for host-to-host cables
51 that contain at least two bulk pipes (one for each direction),
53 the EzLink cable and the NetChip 1080 chip.
55 .\" XXX The description of how to add netgraph to the kernel
56 .\" is out of place here. It should be limited to the
57 .\" netgraph(4) manpage only. However, that page does
58 .\" not yet give instructions for kldload(8) for the
59 .\" clueless. Working on it -- sheldonh
63 This can be done either by adding
64 .Cd "options NETGRAPH"
65 to your kernel configuration file, or alternatively loading
67 as a module, either from
69 or from the command line, before the
89 .Dl ngctl mkpeer udbp0: iface data inet
90 .Dl ifconfig ng0 10.0.0.1 10.0.0.2
92 Create a new network interface node
93 and connect its inet hook to the data hook of the
97 configures the resulting network interface ng0 with a local
98 IP address of 10.0.0.1 and a remote IP address of 10.0.0.2.
99 On the remote host, the two
100 IP addresses should of course be reversed.
111 driver first appeared in
117 driver was written by
118 .An Doug Ambrisko Aq ambrisko@whistle.com ,
119 .An Julian Elischer Aq julian@FreeBSD.org
121 .An Nick Hibma Aq n_hibma@FreeBSD.org .
123 This manual page was written by
124 .An Nick Hibma Aq n_hibma@FreeBSD.org .