2 # Specific board setup for the Atheros AP96 reference board.
4 # The AP96 has the following hardware:
9 # + AR8316 10/100/1000 switch
10 # + m25p64 based 8MB flash
20 options AR71XX_REALMEM=64*1024*1024
22 options AR71XX_ENV_UBOOT
24 # For DOS - enable if required
27 # uncompress - to boot read-only lzma natively from flash
28 device geom_uncompress
29 options GEOM_UNCOMPRESS
30 options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
32 # Used for the static uboot partition map
35 # Options needed for the EEPROM based calibration/PCI configuration data.
36 options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
37 options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
38 device firmware # Used by the above
40 # Options required for miiproxy and mdiobus
41 options ARGE_MDIO # Export an MDIO bus separate from arge
42 device miiproxy # MDIO bus <-> MII PHY rendezvous