2 # Copyright (c) 2002-2008 Sam Leffler, Errno Consulting
5 # Redistribution and use in source and binary forms, with or without
6 # modification, are permitted provided that the following conditions
8 # 1. Redistributions of source code must retain the above copyright
9 # notice, this list of conditions and the following disclaimer,
10 # without modification.
11 # 2. Redistributions in binary form must reproduce at minimum a disclaimer
12 # similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
13 # redistribution must be conditioned upon including a substantially
14 # similar Disclaimer requirement for further binary redistribution.
17 # THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
18 # ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
19 # LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
20 # AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
21 # THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
22 # OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
23 # SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
24 # INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
25 # IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
26 # ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
27 # THE POSSIBILITY OF SUCH DAMAGES.
32 ATH_RATE?= sample # tx rate control algorithm
34 .PATH: ${.CURDIR}/../../dev/ath
35 .PATH: ${.CURDIR}/../../dev/ath/ath_hal
38 SRCS= if_ath.c if_ath_debug.c if_ath_keycache.c if_ath_sysctl.c
39 SRCS+= if_ath_tx.c if_ath_tx_ht.c
40 # NB: v3 eeprom support used by both AR5211 and AR5212; just include it
41 SRCS+= ah_osdep.c ah.c ah_regdomain.c ah_eeprom_v3.c
42 SRCS+= device_if.h bus_if.h pci_if.h opt_inet.h opt_ath.h opt_ah.h opt_wlan.h
45 # AR5210 support; these are first generation 11a-only devices.
47 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5210
48 SRCS+= ah_eeprom_v1.c \
49 ar5210_attach.c ar5210_beacon.c ar5210_interrupts.c \
50 ar5210_keycache.c ar5210_misc.c ar5210_phy.c ar5210_power.c \
51 ar5210_recv.c ar5210_reset.c ar5210_xmit.c
54 # AR5211 support; these are second generation 11b/g/a devices
55 # (but 11g was OFDM only and is not supported).
57 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5211
58 SRCS+= ar5211_attach.c ar5211_beacon.c ar5211_interrupts.c \
59 ar5211_keycache.c ar5211_misc.c ar5211_phy.c ar5211_power.c \
60 ar5211_recv.c ar5211_reset.c ar5211_xmit.c
63 # AR5212 support; this covers all other pci/cardbus legacy parts.
65 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5212
66 SRCS+= ar5212_ani.c ar5212_attach.c ar5212_beacon.c ar5212_eeprom.c \
67 ar5212_gpio.c ar5212_interrupts.c ar5212_keycache.c ar5212_misc.c \
68 ar5212_phy.c ar5212_power.c ar5212_recv.c ar5212_reset.c \
69 ar5212_rfgain.c ar5212_xmit.c
78 # AR5416, AR9130, AR9160, AR9220, AR9280, AR9285 support.
80 # Note enabling this support requires defining AH_SUPPORT_AR5416
81 # in opt_ah.h so the 11n tx/rx descriptor format is handled.
83 # NB: 9160 depends on 5416 but 5416 does not require 9160
86 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar5416
87 SRCS+= ah_eeprom_v14.c ah_eeprom_v4k.c \
88 ar5416_ani.c ar5416_attach.c ar5416_beacon.c ar5416_cal.c \
89 ar5416_cal_iq.c ar5416_cal_adcgain.c ar5416_cal_adcdc.c \
90 ar5416_eeprom.c ar5416_gpio.c ar5416_interrupts.c ar5416_keycache.c \
91 ar5416_misc.c ar5416_phy.c ar5416_power.c ar5416_recv.c \
92 ar5416_reset.c ar5416_xmit.c
94 # RF backend for 5416, 9130 and 9160
98 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9001
99 SRCS+= ar9160_attach.c
101 # + AR9130 - (Sowl) - Embedded (AR913x SoC)
103 # This requires AH_SUPPORT_AR9130 in order to function as some
104 # register values have shifted for this chipset. Definig this however
105 # (currently) breaks non-AR9130 chipsets - since this is an embedded
106 # chipset and no other radios are glued to it, this shouldn't pose a
108 SRCS+= ar9130_attach.c ar9130_eeprom.c ar9130_phy.c
110 # AR9002 series chips
111 # + AR9220/AR9280 - Merlin
112 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9002
113 SRCS+= ar9280.c ar9280_attach.c ar9280_olc.c
116 SRCS+= ar9285.c ar9285_reset.c ar9285_attach.c ar9285_cal.c ar9285_phy.c
117 SRCS+= ar9285_diversity.c
120 .PATH: ${.CURDIR}/../../dev/ath/ath_hal
121 SRCS+= ah_eeprom_9287.c
122 .PATH: ${.CURDIR}/../../dev/ath/ath_hal/ar9002
123 SRCS+= ar9287.c ar9287_reset.c ar9287_attach.c ar9287_cal.c ar9287_olc.c
125 # NB: rate control is bound to the driver by symbol names so only pick one
126 .if ${ATH_RATE} == "sample"
127 .PATH: ${.CURDIR}/../../dev/ath/ath_rate/sample
129 .elif ${ATH_RATE} == "onoe"
130 .PATH: ${.CURDIR}/../../dev/ath/ath_rate/onoe
132 .elif ${ATH_RATE} == "amrr"
133 .PATH: ${.CURDIR}/../../dev/ath/ath_rate/amrr
138 .PATH: ${.CURDIR}/../../dev/ath/ath_dfs/null
141 CFLAGS+= -I. -I${.CURDIR}/../../dev/ath -I${.CURDIR}/../../dev/ath/ath_hal
144 echo '#define AH_SUPPORT_AR5416 1' > $@
146 .include <bsd.kmod.mk>
148 CWARNFLAGS.ah_regdomain.c= ${NO_WSHIFT_COUNT_NEGATIVE} ${NO_WSHIFT_COUNT_OVERFLOW}
149 # XXX Work around clang warnings, until maintainer approves fix.
150 CWARNFLAGS.ah_eeprom_9287.c= ${NO_WSOMETIMES_UNINITIALIZED}
151 CWARNFLAGS.if_ath.c= ${NO_WSOMETIMES_UNINITIALIZED}
152 CWARNFLAGS+= ${CWARNFLAGS.${.IMPSRC:T}}