1 .\" Copyright (c) 2013, Luiz Otavio O Souza <loos@FreeBSD.org>
2 .\" All rights reserved.
4 .\" Redistribution and use in source and binary forms, with or without
5 .\" modification, are permitted provided that the following conditions
7 .\" 1. Redistributions of source code must retain the above copyright
8 .\" notice, this list of conditions and the following disclaimer.
9 .\" 2. Redistributions in binary form must reproduce the above copyright
10 .\" notice, this list of conditions and the following disclaimer in the
11 .\" documentation and/or other materials provided with the distribution.
13 .\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
14 .\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
15 .\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
16 .\" ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
17 .\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
18 .\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
19 .\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
20 .\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
21 .\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
22 .\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
32 .Nd GPIO LED generic device driver
34 To compile this driver into the kernel,
35 place the following lines in your
36 kernel configuration file:
37 .Bd -ragged -offset indent
44 driver provides glue to attach a
46 compatible device to a GPIO pin.
47 Each LED in the system has a
49 which is used to export a device as
51 The GPIO pin can then be controlled by writing to this device as described
59 these values are configurable for
61 .Bl -tag -width ".Va hint.gpioiic.%d.atXXX"
62 .It Va hint.gpioled.%d.at
63 The gpiobus you are attaching to.
64 Normally assigned to gpiobus0.
65 .It Va hint.gpioled.%d.name
66 Arbitrary name of device in
70 .It Va hint.gpioled.%d.pins
71 Which pin on the GPIO interface to map to this instance.
72 Please note that this mask should only ever have one bit set
73 (any other bits - i.e., pins - will be ignored).
74 .It Va hint.gpioled.%d.invert
75 If set to 1, the pin will be set to 0 to light the LED, and 1 to clear it.
84 device usually looks like:
92 compatible = "gpioled";
93 gpios = <&gpio 16 2 0>; /* GPIO pin 16. */
98 compatible = "gpioled";
99 gpios = <&gpio 17 2 0>; /* GPIO pin 17. */
105 Optionally, you can choose to combine all the LEDs under a single
114 compatible = "gpio-leds";
117 gpios = <&gpio 16 2 0>;
122 gpios = <&gpio 17 2 0>;
129 Both methods are equally supported and it is possible to have the LEDs
130 defined with any sort of mix between the methods.
131 The only restriction is that a GPIO pin cannot be mapped by two different
134 For more details about the
136 property, please consult
137 .Pa /usr/src/sys/boot/fdt/dts/bindings-gpio.txt .
141 is the arbitrary name of the device in
153 manual page first appeared in
157 manual page was written by
158 .An Luiz Otavio O Souza .