1 .\" Copyright (c) 2011 Henrik Brix Andersen <brix@FreeBSD.org>
2 .\" All rights reserved.
4 .\" Redistribution and use in source and binary forms, with or without
5 .\" modification, are permitted provided that the following conditions
7 .\" 1. Redistributions of source code must retain the above copyright
8 .\" notice, this list of conditions and the following disclaimer.
9 .\" 2. Redistributions in binary form must reproduce the above copyright
10 .\" notice, this list of conditions and the following disclaimer in the
11 .\" documentation and/or other materials provided with the distribution.
13 .\" THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
14 .\" IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
15 .\" OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
16 .\" IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
17 .\" INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
18 .\" NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
19 .\" DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
20 .\" THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
21 .\" (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
22 .\" THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
31 .Nd Geode LX CS5536 I2C controller driver
33 To compile this driver into the kernel,
34 place the following lines in your
35 kernel configuration file:
36 .Bd -ragged -offset indent
43 Alternatively, to load the driver as a
44 module at boot time, place the following line in
46 .Bd -literal -offset indent
52 driver supports the System Management Bus controller of the Geode LX
53 series CS5536 Companion Device. The Geode LX is a member of the AMD
54 Geode family of integrated x86 system chips.
56 Although AMD refers to this device as a System Management Bus (SMBus)
57 controller, it is really an I2C controller (it lacks SMBus ALERT# and
58 Alert Response support).
62 driver supports both I2C master and slave mode.
66 driver supports the following variable as both
71 .Bl -tag -width indent
72 .It Va dev.glxiic.0.timeout
73 This variable controls the I2C bus timeout in milliseconds. The
74 default timeout is 35 milliseconds. A value of zero disables the
80 driver uses the interrupt line number configured by the board firmware
81 by default. If no interrupt line number has been configured by the
82 board firmware (or to override the interrupt line number configured by
83 board firmware), place the following line in
85 .Bd -ragged -offset indent
86 hint.glxiic.0.irq="10"
89 The interrupt line number must be between 1 and 15.
99 device driver and manual page first appeared in
105 device driver and manual page were written by
106 .An Henrik Brix Andersen Aq Mt brix@FreeBSD.org .