2 # AP135 - the QCA955x SoC reference design
4 # This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
5 # 128MiB RAM, an AR8327 5-port gigabit ethernet switch and
6 # a QCA 11ac 5GHz AP NIC.
8 # The to things not currently support are the QCA 11ac NIC and
9 # PCIe host controllers - there's two of them, and the existing
10 # PCIe code here doesn't support that just yet.
17 # Include the default QCA955x parameters
18 include "QCA955X_BASE"
22 # Override hints with board values
25 # Force the board memory - the base AP135 has 128MB RAM
26 options AR71XX_REALMEM=(128*1024*1024)
34 # Options required for miiproxy and mdiobus
35 options ARGE_MDIO # Export an MDIO bus separate from arge
36 device miiproxy # MDIO bus <-> MII PHY rendezvous
41 # read MSDOS formatted disks - USB
44 # Enable the uboot environment stuff rather then the
46 options AR71XX_ENV_UBOOT
48 # uzip - to boot natively from flash
49 device geom_uncompress
50 options GEOM_UNCOMPRESS
52 # Used for the static uboot partition map
55 # yes, this board has a PCIe connected atheros device
56 # add ath_pci so it can at least attach things when there's a
57 # ath(4) in there, rather than the 11ac chip we don't support.
62 options AR71XX_ATH_EEPROM
63 device firmware # Used by the above
64 options ATH_EEPROM_FIRMWARE
66 # Boot off of the rootfs, as defined in the geom_map setup.
67 options ROOTDEVNAME=\"ufs:map/rootfs.uncompress\"
70 options IPFIREWALL_DEFAULT_TO_ACCEPT