2 # Specific board setup for the Atheros AP96 reference board.
4 # The AP96 has the following hardware:
9 # + AR8316 10/100/1000 switch
10 # + m25p64 based 8MB flash
20 options AR71XX_REALMEM=64*1024*1024
22 options AR71XX_ENV_UBOOT
24 # For DOS - enable if required
29 # uncompress - to boot read-only lzma natively from flash
33 # Used for the static uboot partition map
36 # Boot off of the rootfs, as defined in the geom_map setup.
37 options ROOTDEVNAME=\"ufs:map/rootfs.uzip\"
39 # Options needed for the EEPROM based calibration/PCI configuration data.
40 options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
41 options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
42 device firmware # Used by the above
44 # Options required for miiproxy and mdiobus
45 options ARGE_MDIO # Export an MDIO bus separate from arge
46 device miiproxy # MDIO bus <-> MII PHY rendezvous