1 # This file (and the kernel config file accompanying it) are not designed
2 # to be used by themselves. Instead, users of this file should create a
3 # kernel # config file which includes this file (which gets the basic hints),
4 # then override the default options (adding devices as needed) and adding
5 # hints as needed (for example, the GPIO and LAN PHY.)
14 # NB: This isn't an ns8250 UART
15 hint.uart.0.maddr=0x18020003
16 hint.uart.0.msize=0x18
19 #ehci - note the 0x100 offset for the AR913x/AR724x
20 hint.ehci.0.at="nexus0"
21 hint.ehci.0.maddr=0x1b000100
22 hint.ehci.0.msize=0x00001000
25 hint.arge.0.at="nexus0"
26 hint.arge.0.maddr=0x19000000
27 hint.arge.0.msize=0x1000
30 hint.arge.1.at="nexus0"
31 hint.arge.1.maddr=0x1a000000
32 hint.arge.1.msize=0x1000
35 # XXX The ath device hangs off of the AHB, rather than the Nexus.
36 hint.ath.0.at="nexus0"
37 hint.ath.0.maddr=0x18100000
38 hint.ath.0.msize=0x20000
40 hint.ath.0.vendor_id=0x168c
41 hint.ath.0.device_id=0x0031
42 # Set this to define where the ath calibration data
43 # should be fetched from in physical memory.
44 # hint.ath.0.eepromaddr=0x1fff1000
47 hint.spi.0.at="nexus0"
48 hint.spi.0.maddr=0x1f000000
51 hint.mx25l.0.at="spibus0"
55 hint.ar71xx_wdog.0.at="nexus0"
57 # The GPIO function and pin mask is configured per-board
59 hint.gpio.0.maddr=0x18040000
60 hint.gpio.0.msize=0x1000