1 # This file (and the kernel config file accompanying it) are not designed
2 # to be used by themselves. Instead, users of this file should create a
3 # kernel # config file which includes this file (which gets the basic hints),
4 # then override the default options (adding devices as needed) and adding
5 # hints as needed (for example, the GPIO and LAN PHY.)
12 # ART calibration data mapping device
13 hint.ar71xx_caldata.0.at="nexus0"
14 hint.ar71xx_caldata.0.order=0
18 # NB: This isn't an ns8250 UART
19 hint.uart.0.maddr=0x18020003
20 hint.uart.0.msize=0x18
23 #ehci - note the 0x100 offset for the AR913x/AR724x
24 hint.ehci.0.at="nexus0"
25 hint.ehci.0.maddr=0x1b000100
26 hint.ehci.0.msize=0x00001000
30 hint.pcib.0.at="nexus0"
33 hint.arge.0.at="nexus0"
34 hint.arge.0.maddr=0x19000000
35 hint.arge.0.msize=0x1000
38 hint.arge.1.at="nexus0"
39 hint.arge.1.maddr=0x1a000000
40 hint.arge.1.msize=0x1000
43 # XXX The ath device hangs off of the AHB, rather than the Nexus.
44 hint.ath.0.at="nexus0"
45 hint.ath.0.maddr=0x18100000
46 hint.ath.0.msize=0x20000
48 hint.ath.0.vendor_id=0x168c
49 hint.ath.0.device_id=0x0031
50 # Set this to define where the ath calibration data
51 # should be fetched from in physical memory.
52 # hint.ath.0.eepromaddr=0x1fff1000
54 # Where the ART is - last 64k in the first 8MB of flash
55 #hint.ar71xx_caldata.0.map.0.ath_fixup_addr=0x1fff0000
56 #hint.ar71xx_caldata.0.map.0.ath_fixup_size=16384
58 # And now tell the ath(4) driver where to look!
59 #hint.ath.0.eeprom_firmware="ar71xx_caldata.0.map.0.eeprom_firmware"
62 hint.spi.0.at="nexus0"
63 hint.spi.0.maddr=0x1f000000
66 hint.mx25l.0.at="spibus0"
70 hint.ar71xx_wdog.0.at="nexus0"
72 # The GPIO function and pin mask is configured per-board
74 hint.gpio.0.maddr=0x18040000
75 hint.gpio.0.msize=0x1000