3 # arge0 is connected to the LAN side of the switch PHY.
4 # arge1 is connected to the single port WAN side of the switch PHY.
6 hint.arge.0.phymask=0x0
9 hint.arge.0.eeprommac=0x1f66ffa0
10 hint.arge.0.readascii=1
12 hint.arge.1.phymask=0x0
13 hint.arge.1.media=1000
15 hint.arge.1.eeprommac=0x1f66ffb4
16 hint.arge.1.readascii=1
19 hint.pcib.0.bus.0.17.0.ath_fixup_addr=0x1f661000
20 hint.pcib.0.bus.0.17.0.ath_fixup_size=4096
23 hint.pcib.0.bus.0.18.0.ath_fixup_addr=0x1f665000
24 hint.pcib.0.bus.0.18.0.ath_fixup_size=4096
26 # .. and now, telling each ath(4) NIC where to find the firmware
28 hint.ath.0.eeprom_firmware="pcib.0.bus.0.17.0.eeprom_firmware"
29 hint.ath.1.eeprom_firmware="pcib.0.bus.0.18.0.eeprom_firmware"
35 # The DIR-825 has an 8MB flash part - HOWEVER, the 64k caldata isn't
36 # at the end of the flash. It's ~ 6MB into the flash image.
38 # mtdparts=ar7100-nor0:256k(uboot),64k(Config),1024k(vmlinux),5184k(rootfs),64k(caldata)
40 hint.map.0.at="flash/spi0"
41 hint.map.0.start=0x00000000
42 hint.map.0.end=0x000040000
43 hint.map.0.name="uboot"
46 # This config partition is the D-Link specific configuration area.
47 # I'm re-purposing it for FreeBSD.
48 hint.map.1.at="flash/spi0"
49 hint.map.1.start=0x00040000
50 hint.map.1.end=0x00050000
54 hint.map.2.at="flash/spi0"
55 hint.map.2.start=0x0050000
56 hint.map.2.end=0x00150000
57 hint.map.2.name="kernel"
60 hint.map.3.at="flash/spi0"
61 hint.map.3.start=0x00150000
62 hint.map.3.end=0x00660000
63 hint.map.3.name="rootfs"
66 hint.map.4.at="flash/spi0"
67 hint.map.4.start=0x00660000
68 hint.map.4.end=0x00670000