2 # Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
4 # The Engenius ENH-200 has the following hardware:
21 options AR71XX_REALMEM=32*1024*1024
23 options AR71XX_ENV_UBOOT
25 # For DOS - enable if required
28 # uncompress - to boot read-only lzma natively from flash
31 options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"
33 # Used for the static uboot partition map
36 # Options needed for the EEPROM based calibration/PCI configuration data.
37 options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
38 options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
39 device firmware # Used by the above
41 # Options required for miiproxy and mdiobus
42 options ARGE_MDIO # Export an MDIO bus separate from arge
43 device miiproxy # MDIO bus <-> MII PHY rendezvous