4 # There's two interfaces, but only one socket is populated.
6 # There's an AR8021 PHY attached to arge1.
8 # XXX TODO: figure out where to extract the MAC from.
9 hint.arge.1.phymask=0x01
11 # XXX TODO: pass in hints for the GPIO -> LED mapping for the
12 # minipci slot. The specific customer reference design NIC
13 # wires GPIO5 from each AR9220 to one of two GPIO pins on the
14 # MiniPCI bus. However, this may be very specific to the NIC
17 # The default flash layout:
21 # uimage (kernel): 1728k
24 # We steal 64k from the end of rootfs to store the local config.
26 hint.map.0.at="flash/spi0"
27 hint.map.0.start=0x00000000
28 hint.map.0.end=0x000030000
29 hint.map.0.name="uboot"
32 hint.map.1.at="flash/spi0"
33 hint.map.1.start=0x00030000
34 hint.map.1.end=0x00040000
35 hint.map.1.name="uboot-env"
38 hint.map.2.at="flash/spi0"
39 hint.map.2.start=0x00040000
40 hint.map.2.end=0x00630000
41 hint.map.2.name="rootfs"
44 hint.map.3.at="flash/spi0"
45 hint.map.3.start=0x00630000
46 hint.map.3.end=0x00640000
50 hint.map.4.at="flash/spi0"
51 hint.map.4.start=0x00640000
52 hint.map.4.end=0x007f0000
53 hint.map.4.name="kernel"
56 hint.map.5.at="flash/spi0"
57 hint.map.5.start=0x007f0000
58 hint.map.5.end=0x00800000
62 # Don't flip on anything that isn't already enabled by the
64 hint.gpio.0.function_set=0x00000000
65 hint.gpio.0.function_clear=0x00000000
67 # Which GPIO lines to enable - just GPIO2/3 for the LEDs.
68 hint.gpio.0.pinmask=0x0000000c
70 # GPIO2 and GPIO3 are LEDs, where 0=on and 1=off.
71 # XXX TODO: teach gpioled about polarity?
72 hint.gpioled.0.at="gpiobus0"
73 hint.gpioled.0.pins="0x0004"
74 hint.gpioled.0.name="led1"
76 hint.gpioled.1.at="gpiobus0"
77 hint.gpioled.1.pins="0x0008"
78 hint.gpioled.1.name="led2"