1 # This file (and the kernel config file accompanying it) are not designed
2 # to be used by themselves. Instead, users of this file should create a
3 # kernel config file which includes this file (which gets the basic hints),
4 # then override the default options (adding devices as needed) and adding
5 # hints as needed (for example, the GPIO and LAN PHY.)
10 # The default APB is on IP6 (irq4); we need to add
11 # the two new ones (IP2, IP3) to this and extend
12 # the irq ranges appropriately.
17 # NB: This isn't an ns8250 UART
18 hint.uart.0.maddr=0x18020003
19 hint.uart.0.msize=0x18
23 hint.ehci.0.at="nexus0"
24 hint.ehci.0.maddr=0x1b000100
25 hint.ehci.0.msize=0x00001000
28 hint.ehci.1.at="nexus0"
29 hint.ehci.1.maddr=0x1b400100
30 hint.ehci.1.msize=0x00001000
33 # PCIe 1: qca955x_int0 (IP2)
35 # pci - XXX no maddr/msize, grr!
36 hint.pcib.0.at="nexus0"
39 # XXX TODO: PCIe 1: qca955x_int1 (IP3)
42 hint.arge.0.at="nexus0"
43 hint.arge.0.maddr=0x19000000
44 hint.arge.0.msize=0x1000
48 hint.arge.1.at="nexus0"
49 hint.arge.1.maddr=0x1a000000
50 hint.arge.1.msize=0x1000
53 # ath0 - connected via IP2 mux
54 hint.ath.0.at="nexus0"
55 hint.ath.0.maddr=0x18100000
56 hint.ath.0.msize=0x20000
58 hint.ath.0.vendor_id=0x168c
59 hint.ath.0.device_id=0x0039
60 # Set this to define where the ath calibration data
61 # should be fetched from in physical memory.
62 # hint.ath.0.eepromaddr=0x1fff1000
65 hint.spi.0.at="nexus0"
66 hint.spi.0.maddr=0x1f000000
69 hint.mx25l.0.at="spibus0"
73 hint.ar71xx_wdog.0.at="nexus0"
75 # The GPIO function and pin mask is configured per-board
77 hint.gpio.0.maddr=0x18040000
78 hint.gpio.0.msize=0x1000