Simplify UIO_SYSSPACE and UIO_NOCOPY paths in uiomove
Uiomove can only block when the segflag is UIO_USERSPACE,
otherwise we end up just doing a bcopy (or nothing) and
moving cursors. So only emit witness warnings and
set deadlock thread flags in the UIO_USERSPACE case.
rtwn: add Rx descriptor structures for common code.
Remove any chipset specific usage of Rx descriptor structure / bits
from common code to prevent misuse of fields that may differ
between various chipsets.
:l_flag:: be more aggressive when normalizing whitespace
Save output from ls -ldT and stat -l, then normalize all repeating whitespace using
sed to single column spaces.
This makes the test flexible with single-digit days, etc, similar to r320723. This
approach is just a bit more of a hammer approach because of how the columns are
ordered/spaced in both ls and stat.
Formalize LEAPSECONDS and OLDTIMEZONES in share/zoneinfo/... as
`MK_ZONEINFO_LEAPSECONDS_SUPPORT == yes` and
`MK_ZONEINFO_OLD_TIMEZONES_SUPPORT == yes`.
Keep `LEAPSECONDS` and `OLDTIMEZONES` for backwards compatibility,
but print out a warning notifying users that they should use the new
variables, in an effort to migrate them to the variables. This is being
done mostly for automated build tools, etc, that might rely on these
variables being set. The variables will be removed in the future on
^/head, e.g., after ^/stable/12 is cut.
Remove SUBDIR ordering/uniquifying in *bin/Makefile
After the addition of SUBDIR.yes, uniquifying/ordering the SUBDIRs doesn't
make a whole lot of sense, and it's in effect a half measure.
Ordering SUBDIR (after adding SUBDIR.yes to it) in bsd.subdir.mk is a
separate change that warrants more discussion/testing, because while
the SUBDIR_PARALLEL work largely fixed dependency ordering for SUBDIRs,
there might be downstream FreeBSD consumers that rely on the SUBDIR
ordering.
Add support for AF_LOCAL socket upcalls to the nfsuserd daemon.
This patch adds support for AF_LOCAL socket upcalls to an nfsuserd daemon
that supports them. A future patch to the nfsuserd daemon will use AF_LOCAL
sockets to avoid a problem when using upcalls to 127.0.0.1 if jails are
in use.
Defer ACPI taskqueue creation to SI_SUB_KICK_SCHEDULER.
This addresses a deadlock during boot when EARLY_AP_STARTUP is configured:
a taskqueue thread may call pause() with an ACPI mutex held, and thread0
may block on this mutex before configuring the eventtimer. In this case
the taskqueue thread will sleep forever waiting for its callout to fire.
- Support for X550EM devices.
- Support for Bypass adapters.
- Flow Director code moved to separate files
- SR-IOV code moved to separate files
- Netmap code moved to separate files
Differential Revision: https://reviews.freebsd.org/D11232
Submitted by: Jeb Cramer <cramerj@intel.com>
Reviewed by: erj@
Tested by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Sponsored by: Intel Corporation
ZFS SLOGs have very specific access pattern with many cache flushes,
which none of benchmarks I know can simulate. Since SSD vendors rarely
specify cache flush time, this measurement can be useful to explain why
some ZFS pools are slower then expected. This test writes data chunks
of different size followed by cache flush, alike to what ZFS SLOG does,
and measures average time.
To illustrate, here is result for 6 years old SATA Intel 710 Series SSD:
While the first one obviously has maximal throughput limitations, the
second one has so high cache flush latency (about 2 millisecond), that
it makes one almost useless in SLOG role, despite of its good throughput
numbers. Power loss protection is out of scope of this test, but I
suspect it can be related.
Don't overpromote values when calculating len in tcp_output().
sbavail() returns u_int and sendwin is a uint32_t. Therefore, min() (which
operates on two u_int values) is able to correctly calculate the minimum
of these two arguments.
Even though gdb and kgdb may not be removed for 12.0 on some architectures,
the notice is unconditional as these tools will likely be removed at some
point in the future when adequate replacements are available (gdb in ports
or lldb in base).
Reviewed by: emaste
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D11477
Add option to bsdinstall to disable insecure console, update stack guard option
This patch adds new bsdinstall option to hardening section that allows users
to change this behaviour to secure one and updates stack guard option so it
would set the value of relevant sysctl to 512 (2MB)
Run "resizewin -z" from the default shell profile files. This makes
the terminal work properly out of the box when logging over a serial
line, which is quite important for the user experience on boards like
Raspberry Pi. It doesn't affect cases where the terminal size is
already non-zero, such as SSH or vt(4) sessions.
Note that this doesn't handle a scenario pointed out by rgrimes@:
when the terminal is resized after login, the terminal size won't
get updated even after logging out and back in.
andrew [Wed, 5 Jul 2017 10:29:05 +0000 (10:29 +0000)]
Make MULTIDELAY a requirement in the MPCore Timer driver when using
PLATFORM. This will help with removing the MULTIDELAY option, enabling
it when PLATFORM is enabled.
andrew [Wed, 5 Jul 2017 09:27:18 +0000 (09:27 +0000)]
Require the ARM Generic Timer driver is built for MULTIDELAY on 32bit arm.
As this driver is also used for DELAY on arm64 we need to keep the existing
DELAY code for it to use.
Add a Bugs section that indicates that the nfsuserd doesn't work
when jails are being used on the system.
It is hoped that the patches in PR#205193 will someday get tested/debugged
so that they can be committed to fix this.
ian [Tue, 4 Jul 2017 18:38:34 +0000 (18:38 +0000)]
Add a driver for the imx6 on-chip realtime clock.
This driver is standard rather than optional because it can always provide
time after a reboot, but it will only provide time after a power cycle if
battery power is supplied to the chip's SNVS power domain.
After r319722 two fields were left uninitialized when transforming a
socket structure into a listening socket. This resulted in an invalid
instruction fault for all 32-bit platforms.
When INVARIANTS is set the union where the two uninitialized fields
reside gets properly zeroed. This patch ensures the two uninitialized
fields are zeroed when INVARIANTS is undefined.
For 64-bit platforms this issue was not visible because so->sol_upcall
which is uninitialized overlaps with so->so_rcv.sb_state which is
already zero during soalloc();
For 32-bit platforms this issue was visible and resulted in an invalid
instruction fault, because so->sol_upcall overlaps with
so->so_rcv.sb_sel which is always initialized to a valid data pointer
during soalloc().
Verifying the offset locations mentioned above are identical is left
as an exercise to the reader.
RX lock is no longer required. There can only be one RX cleanup task
running at a time, RX cleanup cannot be executed if interface is not
yet initialized and ena_down() will not free any RX resources if any io
interrupt is being handled - RX cleanup task is only called from an
interrupt handler.
Submitted by: Michal Krawczyk <mk@semihalf.com>
Obtained from: Semihalf
Sponsored by: Amazon.com Inc.
If drbr_advance() is not called before doing cleanup and packet is
already enqueued for sending (tx_info is holding pointer to mbuf), then
mbuf is cleaned both in drbr_flush() and in cleanup routine, when all
mbufs hold by tx_buffer_info are being released.
This causes panic, because mbuf is released twice.
Submitted by: Michal Krawczyk <mk@semihalf.com>
Obtained from: Semihalf
Sponsored by: Amazon.com Inc.
Unmask all IO irqs after driver state is set as running
If driver left MSI-x handlling routine because interface was put down,
it is not unmasking IRQs, so any requesting interrupt will be awaiting
for unmasking.
On ena_up() routine all interrupts are being unmasked and any awaiting
interrupt will be handled right away.
If handler was executed before driver state was set as running, handling
routine is being ended immediately, leaving IO irqs for given queue
masked.
Submitted by: Michal Krawczyk <mk@semihalf.com>
Obtained from: Semihalf
Sponsored by: Amazon.com Inc.
Fix a few issues with the lockstat provider man page.
- Address most of the post-commit comments on D11128.[1]
- Reference the man pages for the lock types supported by the provider.
- Add a BUGS section.
- Eliminate some redundancy by describing similar probes in the same
paragraph.
- Fix several inaccuracies, particularly in the probe argument
descriptions.
marius [Mon, 3 Jul 2017 20:47:32 +0000 (20:47 +0000)]
Correct a typo in the comment part of r320577, later on copied into
the commit message; as actually implemented, the intent is to retry
up to 2 ms for controllers to enable bus power.
Noticed by: ian@, rgrimes@
Additional note: Among others, the problem addressed by r320577 is
the APL32 ("Storage Controllers May Not Be Power Gated") erratum.
Hopefully, along with r318282, r320577 works around the remaining
problems seen with Intel Apollo Lake eMMC and SDXC controllers.
Resolve confusion between different error code spaces.
The vm_map_fixed() and vm_map_stack() VM functions return Mach error
codes. Convert them into errno values before returning result from
exec_new_vmspace().
While there, modernize the comment and do minor style adjustments.
Reviewed by: alc
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
manu [Mon, 3 Jul 2017 19:30:03 +0000 (19:30 +0000)]
allwinner: Add A64 ccung support
Upstream DTS for A64 SoC doesn't provide a /clocks node as Linux switched
to ccu-ng
This commit adds the necessary bits to boot on pine64 with latest DTS from
upstream.
USB is not working for now and some node aren't present in the DTS (like the
PMU, Power Management Unit).
iflib - reset fl-ifl_fragidx to 0 on iflib_fl_bufs_free(). This caused the
panic in em/igb when adding it to a bridge device.
iflib - Handle out of order packet delivery from hardware in support of LRO
Out of order updates to rxd's is fixed in r315217. However, it is not
completely fixed. While refilling the buffers, iflib is not considering
the out of order descriptors. Hence, it is refilling sequentially.
"idx" variable in _iflib_fl_refill routine is incremented sequentially.
By doing refilling sequentially, it will override the SGEs that
are *IN USE* by other connections. Fix is to maintain a bitmap of
rx descriptors and differentiate the used one with unused one and
refill only at the unused indices. This patch also fixes a
few bugs in bnxt, related to the same feature.
Switch fabric scans from GID_FT to GID_PT+GFF_ID/GFT_ID.
Instead of using GID_FT SNS request to get list of registered FCP ports,
use GID_PT to get list of all Nx_Ports, and then use GFF_ID and/or GFT_ID
requests to find whether they are FCP and target capable.
The problem with old approach is that GID_FT does not report ports without
FC-4 type registered. In particular it was impossible to boot OS from
FreeBSD FC target using QLogic FC BIOS, since one does not register FC-4
type even on new cards and so ignored by old code as incompatible.
As a side bonus this allows initiator to skip pointless logins to other
initiators by fetching that information from SNS instead.
In case some switches do not implement GFF_ID/GFT_ID correctly, add sysctls
to disable that functionality. I handled broken GFF_ID of my Brocade 200E,
but there may be other switches with different bugs.
Linux also uses GID_PT, but GFF_ID is disabled by default there, and GFT_ID
is not supported.
ed(1): Allow the omission of one address in (.,.) and (.;.) address ranges
With this patch, ",n" is an abbreviation for "1,n", ";n" abbreviates
".;n". The "n," and "n;" variants mean "n,n" and "n;n", respectively.
Also, piping to a shell command does not count as a save, so don't reset
the modified flag.
Fix Vagrant image upload after recent API changes.
- Update ATLAS_UPLOAD_URL to avoid various regular expressions
from failing to match due to redirections.
- Use ATLAS_UPLOAD_URL throughout the script.
- Adjust several regular expression patterns.
MFC after: 3 days
Sponsored by: The FreeBSD Foundation
marius [Sun, 2 Jul 2017 19:13:01 +0000 (19:13 +0000)]
Retry up to 20 ms to enable bus power as at least with some Intel
SDHCI/eMMC controllers the first attempt after a D3 to D0 transition,
i. e. when the firmware has put the devices into D3 state before,
can fail.
andrew [Sun, 2 Jul 2017 08:52:08 +0000 (08:52 +0000)]
In the arm64 pmap_remove, when removing a full superpage there is no need
to demote it to 512 pages, then remove each of these. We can just remove
the l2 map directly. This is what the intel pmaps already do.
projects / FreeBSD / FreeBSD.git / log