$ vipw
[corrupt a line in editor, exit editor]
pwd_mkdb: corrupted entry
pwd_mkdb: at line #2
pwd_mkdb:
/etc/pw.012585: Inappropriate file type or format
re-edit the password file? [y]: n^D^D
[hang]
David Greenman [Mon, 29 Sep 1997 11:27:43 +0000 (11:27 +0000)]
Work around a bug in the 82557 NIC where the receiver will lock up
if it is in 10Mbps mode and gets certain types of garbage prior to
the packet header. The work-around involves reprogramming the
multicast filter if nothing is received in some number of seconds
(currently set at 15). As a side effect, implemented complete support
for multicasting rather than the previous 'receive all multicasts'
hack, since we now have the ability to program the filter table.
Fixed a serious bug which crept in with the timeout() changes;
the cookie was only saved on the first timeout() call in fxp_init()
and wasn't updated in the most common place in fxp_stats_update()
when the timeout was rescheduled. This bug would have resulted in
an eventual panic if fxp_stop() was called (which happens when any
interface flags are changed, for example).
Fixed a bug in Alpha support that would have caused the TxCB
descriptor chain to span a page boundry, causing serious problems
if the pages didn't happen to be contiguous.
Removed some gratuitous bit masking that was left over from an
older implementation.
Fixed a bug where too much was copied from the configuration
template, spilling over into memory that followed it.
Fixed handling of if_timer...it was cleared too early in some cases.
Brian Somers [Sun, 28 Sep 1997 20:17:59 +0000 (20:17 +0000)]
Test for the existence of ../../secure rather
than /usr/include/des.h before building with MSChap.
support. Also allow -DNOCRYPT (as well as -DNOSECURE)
as an override
sbin/init example pointed out by: bde
Fix a serious bug I introduced while adding in support for CAM interrupts.
It seems I didn't count my 0's properly when adding the new masks into
icu_vector.s pushing SWI_AST_MASK off the end of the array and screwing
up the indexing for SWI_CLOCK_MASK.
Fix the bug icu_vector.s and also reformat the code in both icu_vector.s and
apic_vector.s so that it will be much harder to make the same mistake in
the future.
Stephen McKay [Sun, 28 Sep 1997 16:25:28 +0000 (16:25 +0000)]
When bootstrapping lex, the object directory for lex/lib would be deleted
without being recreated. A read-only source compile would then fail shortly
afterwards trying to write .depend into the source tree.
Stephen McKay [Sun, 28 Sep 1997 15:48:34 +0000 (15:48 +0000)]
Add a small hack to support the strange antics of the Unisys ELI 4003. This
machine generates an NMI for each floating point error, just like an old XT.
Since it is ISA only, reading the EISA status port yields 0xff, which would
give a spurious EISA panic. The simplest thing to do is to ignore the 0xff.
Mark Murray [Sun, 28 Sep 1997 09:02:16 +0000 (09:02 +0000)]
Changes for KTH KerberosIV.
Quieten -Wall a bit.
From Joe Traister:
The previous patch did not propogate the KRBTKFILE environment variable
into the new environment when -l is given to su, making it impossible
for kdestroy to find the ticket file. This patch corrects that problem
as well as the original segfault problem.
(Fixes PR 3903)
Mark Murray [Sun, 28 Sep 1997 08:40:54 +0000 (08:40 +0000)]
There is a clear separation of the crypto telnet and the non-crypto telnet.
As this is the non-crypto version, remove the useless (commented out)
directives and macros.
Add support to the host driver for "downloaded constants". These are immediate
operands that are set during seqeuncer program download instead of at
assembly time.
Remove the REJBYTE sram variable. The host driver can just as easly
read the accumulator to get this value.
This should fix the reported problems with cards that don't have devices
attached to them failing with a stream of "Somone reset bus X" messages.
Doug Ledford determined the cause of the problem, fixes by me.
Add support to aicasm for "downloaded constants". These are immediate
operands that are set during seqeuncer program download instead of at
assembly time.
Convert the sequencer code to use" downloaded constants" for four run time
constants that vary depending on the board type. This frees up 4 bytes
of sequencer scratch ram space where these constants used to be stored and
also removes the additional instructions required to load their values
into the accumulator prior to using them.
Remove the REJBYTE sram variable. The host driver can just as easly
read the accumulator to get this value.
The scratch ram savings is important as the old code used to clober the
SCSICONF register on 274X cards which sits near the top of scratch ram
space. The SCSICONF register controls bus termination, and clobbering
it is not a good thing. Now we have 4 bytes to spare.
This should fix the reported problems with cards that don't have devices
attached to them failing with a stream of "Somone reset bus X" messages.
Doug Ledford determined the cause of the problem, fixes by me.
Clustered read and write are switched at mount-option level.
1. Clustered I/O is switched by the MNT_NOCLUSTERR and MNT_NOCLUSTERW
bits of the mnt_flag. The sysctl variables, vfs.foo.doclusterread
and vfs.foo.doclusterwrite are deleted. Only mount option can
control clustered I/O from userland.
2. When foofs_mount mounts block device, foofs_mount checks D_CLUSTERR
and D_CLUSTERW bits of the d_flags member in the block device switch
table. If D_NOCLUSTERR / D_NOCLUSTERW are set, MNT_NOCLUSTERR /
MNT_NOCLUSTERW bits will be set. In this case, MNT_NOCLUSTERR and
MNT_NOCLUSTERW cannot be cleared from userland.
3. Vnode driver disables both clustered read and write.
4. Union filesystem disables clutered write.
1) Bring '!!' back since we wan't overflow even a char
2) Revive __maskrune, just return mask now
3) Express __istype via !!__maskrune
4) Use __maskrune in digittoint
tiny update of ESC sequence parser.
- some addition of comments (for readability)
- iso-2022 G0 designation support. This does almost nothing. Just for
avoiding garbled screen when got "ESC ( B".
(how about G1/2/3 designation? I'm not sure)
Oops, wrong version of digittoint fix was commited, step back to v1.8
instead just remove '!!' to make digittoint() work and re-arrange
things a little
Reduce the target number of vnodes on the freelist from desiredvnodes
(usually a couple of thousand) to 25. The measured impact on cache-hits
doesn't justify spending memory this way:
Target number of free vnodes versus namecache hit rate in % during a
make world:
10 98.5316
200 98.5479
500 98.5546
1000 98.5709
3000 98.6006
4000 98.6126
David Greenman [Thu, 25 Sep 1997 15:49:37 +0000 (15:49 +0000)]
Fix a bug where the speculative memory probe wouldn't occur on systems that
report slightly more than 64MB of total memory. This can happen due to the
total being the sum of both base and extended memory.
Submitted by: Alan Cox <alc@cs.rice.edu>